Torquemaster Conversion To Torsion Spring Kit For Wayne Dalton 9600 Garage Door

Description

This kit is for a Model 9600 Wayne Dalton.  Size selected above.  For heights not listed round up to the next foot.
This kit is to convert your broken Torque Master spring system to an industry standard torsion system.
This kit includes everything you will need except for the tube also referred to as the shaft.  See notes below for more details
Included are the following items.
(1) Standard 15,000 cycle spring. This spring is calculated for this door.
(1) Pair of residential end bearing plates.
(1) Residential center bearing spring mount.
(1) Pair of standard residential drums.
(1) Pair of standard residential cables.
(1) Hardware bag (Includes all hardware needed for conversion).
****Does not include tube shaft.****
We don't include the shaft since it would be cost prohibitive to ship.  Tube needed will need to be 1' longer than the door is wide.  Example a 9' wide door will need a 10' tube/shaft.  Tube is standard 1" outside diameter steel tube, very thin wall such as .060", .083" or .090".  This tube should cost less than .00 at any local metal supply or a local door company.
If you are not sure what model of door you have we can help.  The easiest way is on a 9100 model the inside will have a hard cardboard like backer.  A 9600 will be the same metal on the inside and outside.  Also feel free to send us a picture of the inside of the door and we can let you know as well.
We are a full service garage door company located in Avon, IN and have any and all parts you may need.  If you can't find the parts you are looking for please send us a message and we will make a listing for you.
Currently kit does not include instructions since there are simple to many variables in a conversion. But once the torque master system is removed this kit will install like any standard torsion spring kit.